|
Change Fuel Flow Parameter. |
Post Reply 
|
| Author | |
Lance 33 
Newbie 
Joined: 24 Apr 2020 Location: Australia Status: Offline Points: 7 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: Change Fuel Flow Parameter.Posted: 25 Apr 2020 at 8:49pm |
|
In my Cirrus SR20 I have recently had my Engine Fuel Flow on Take off increased to 19.2 gph. So now on every take off I see a red alert because 19.2 is higher than Fuel Flow parameter set in MFD. Have been into MFD Aux page but cannot see where to adjust FF Parameter? Any suggestions please? Thanks Lance |
|
|
Lance
|
|
 |
|
|
AviSteve
Admin Group 
Joined: 12 Feb 2018 Location: Melbourne, FL Status: Offline Points: 2274 |
Post Options
Thanks(0)
Quote Reply
Posted: 26 Apr 2020 at 2:45pm |
|
That value is not user configurable. During MFD development, it was imposed/specified by the manufacturer.
|
|
|
Steve Lindsley
Avidyne Engineering |
|
|
|
|
Lance 33
Newbie
Joined: 24 Apr 2020 Location: Australia Status: Offline Points: 7 |
Post Options
Thanks(0)
Quote Reply
Posted: 26 Apr 2020 at 8:37pm |
|
Thanks Steve.
|
|
|
Lance
|
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options