GTX327 to AXP340 wiring
Printed From: Avidyne
Category: Avidyne General
Forum Name: AXP340/322 ADS-B Transponder
Forum Description: Topics on the Avidyne AXP340/322 ADS-B Transponder
URL: http://forums.avidyne.com/forum_posts.asp?TID=1620
Printed Date: 25 Dec 2024 at 1:09pm
Software Version: Web Wiz Forums 12.01 - http://www.webwizforums.com
Topic: GTX327 to AXP340 wiring
Posted By: dan300
Subject: GTX327 to AXP340 wiring
Date Posted: 09 Oct 2018 at 2:57pm
|
Anybody have the pin-for-pin to do this?
This is what I have:   |
Replies:
Posted By: forkauto
Date Posted: 09 Oct 2018 at 3:45pm
Here you go! |
Posted By: dan300
Date Posted: 09 Oct 2018 at 4:13pm
|
Thanks for the response, but I don't think that is what I'm looking for. I need to connect a GTX327 harness to a AXP340. |
Posted By: Ibraham
Date Posted: 10 Oct 2018 at 10:14am
| Are you replacing GTX327 with AXP340? |
Posted By: dan300
Date Posted: 10 Oct 2018 at 10:39am
|
Yes |
Posted By: Ibraham
Date Posted: 10 Oct 2018 at 11:24am
| To be ADS-B compliant, the AXP340 needs an approved WAAS GPS navigator to supply GPS position, which is not the case for the GTX327, therefore you may need to replace the harness. Which WAAS GPS do you have? Do you have an experimental aircraft? |
Posted By: dan300
Date Posted: 10 Oct 2018 at 9:08pm
|
Cirrus with two GNS430W. There's a wire from GPS1 to pin 2 on the GTX327. I think putting it to pin 3 of the secondary connector like shown above takes care of the WAAS in. Existing wiring:  |
Posted By: Ibraham
Date Posted: 11 Oct 2018 at 11:58am
This installation requires an avionics shop with an A&P signoff. Unless you have weather and traffic, GTX345 may be a better option (will also display weather and traffic on the MFD with release 8.2 software). FYI, here is the AXP340 basic interconnect diagram. |
Posted By: dan300
Date Posted: 11 Oct 2018 at 12:17pm
| Yes, I'm just doing some legwork for my avionics guy. He hasn't done a 340 yet. I have weather and traffic and a used 340. |
Posted By: Ibraham
Date Posted: 11 Oct 2018 at 6:14pm
| You should call Avidyne tech support, they are very helpful and will provide the avionics tech all the documentation and help needed to get it done. |